Brake lever MAGURA MT5, aluminium lever blade, 2-finger

• brake lever body is made of unique Carbotecture® material developed by MAGURA for its MT brakes
• brake comes with a 2-finger aluminum lever with excellent modulation and high power transfer thanks to the longer lever
• detachable handlebar clamp is made of Carbotecture® material. (the lever can be removed without removing the grips)
• clamp can be replaced with a shiftmix for mounting Shimano or Sram shifters (sold separately)
• lever is equipped with an EBT bleed screw (Easy Bleed Technology) for easy bleeding
• MAGURA MT5 brake lever is reversible, or flip-flop, so you can use it on either your left or right hand
• MAGURA MT5 lever offers the option of adjusting the distance of the lever from the handlebars using a Torx T25 wrench

Weight

• Weight of complete lever = 86 g

Important information

• Read the following warnings carefully!
• Failure to follow these warnings may result in injury or death!
• Failure to follow the warnings below may void your warranty!

WARNING!

For correct installation of the brake lever, it is first necessary to correctly align the arrows stamped on the MAGURA MT handlebar clamp (arrows pointing upwards). First, tighten the upper clamp screw so that there is no gap between the lever and the clamp, then tighten the lower clamp screw. Normally, there should be a 2-3 mm gap between the clamp and the lever at the lower screw. Do not overtighten the screws beyond a torque of 3Nm. Overtightening the screws or incorrect tightening of the top and bottom screws may cause the clamp to break, and this damage is not covered by the warranty!

WARNING!

Use MAGURA ROYAL BLOOD mineral oil as the brake fluid!
Never use DOT fluid, as it will damage the seals and the brake lever will have to be discarded.