Brake pads MAGURA 7.R Race, MT2, MT4, MT8, MT SPORT, MT TRAIL

• MAGURA 7.R brake pads Race compound
• MAGURA 7.R Race brake pads are organic compounds (resin)
• The Race compound is designed for those who go to the limit and require high braking performance with immediate onset on steep descents regardless of lower power modulation
• MAGURA 7.R Race pads are designed for performance/racing riders and fast downhill rides as well as where a sharp increase in braking power is required followed by another fast pass
• the pads are suitable if the rider does not stand on the brakes for the entire length of the hill (top to bottom), but gives the pads room to cool down

Expect extreme bite and higher noise (squeaking) with these plates, so better dosage = more sensitive fingers. The pads have a lower life span just because of the higher "bite", so they are not suitable for riders who brake the whole hill (standing on the brakes). Before your first steep descent, we recommend to ride the pads see below and then test them on a familiar and stable surface.

Brake pads bedd-in!

To achieve maximum braking performance, all newly fitted pads need to be run in, an important process that should not be skipped! If the pads are not seated, the pad surface can "glass", which seriously affects the frictional properties of the pads and leads to a deterioration in braking performance.

For this purpose, choose a flat/non-slippery surface without traffic. Run the bike at a speed of approx. 30 km/h. Slow down to a stop with one brake. Brake firmly, but not into a skid. Repeat this procedure at least 30 times with each brake separately. The brake pads and discs will engage and provide optimum braking performance.

Sintered pads take much longer to break in than organic compound (resin) pads. Keep this in mind when purchasing sintered compound pads and extend your break-in time! In general, the more durable the pad compound, the longer the pads will take to run in. Brakes will reach their full to potential after a few runs!

MAGURA plate run-out limit

The limit when MAGURA pads are considered worn or require replacement with new ones is if they are less than 2.5mm high (including the carrier base).

If the pads have less than this amount of compound, we recommend replacing them immediately with new ones to avoid damage to the braking system or injury to the rider!

Pads are compatible with brake calipers

• MAGURA MT2
• MAGURA MT SPORT
• MAGURA MT TRAIL SPORT (zadní 2-píst)
• MAGURA MT TRAIL SL (zadní 2-píst)
• MAGURA MT4
• MAGURA MT4 eSTOP
• MAGURA MT C4
• MAGURA MT6
• MAGURA MT8
• MAGURA MT8 Raceline
• MAGURA MT8 PRO
• MAGURA MT8 SL

Contents of the package

• 2x MAGURA 7.R Race pads (for 1 brake)
• 1x locking screw for pads in caliper

Choosing the right MAGURA brake pads