Brake pads HOPE GR4, TR4, V4, racing, green (without accessories)

• brake pads HOPE Racing, green (without accessories)
• HOPE Racing brake pads are designed for extreme conditions
• HOPE Racing pads deliver stable performance even in high temperatures and harsh conditions
• Ideal for extreme descents where brakes are exposed to maximum temperatures
• pads have reduced braking noise
• the use of genuine HOPE discs also reduces vibrations during braking even under high loads
• for these plates, the plate beddin time has been reduced so that they work without the risk of low braking power also at lower temperatures

Thanks to the above features, the rider gets consistent brake response with the same behaviour throughout the life of the pads, which improves bike handling and increases riding confidence and safety.

Brake pads compactible with brakes

• HOPE Tech 3 V4
• HOPE Tech 4 V4
• HOPE Tech 4 EVO GR4
• HOPE Tech 4 EVO TR4

Package content

• 2x brake pad HOPE Racing (for 1 brake)

Brake pads bedding process

To achieve maximum braking performance all newly fitted pads will need bedding in, this is an important process and should not be skipped. If pads are not bedded in the pad surface will become glazed, severely affecting the frictional properties of the pads, resulting in poor braking performance.

To bed in the pads, ride at a moderate speed, rolling down a gentle slope is perfect. Gently apply the brake without attempting to fully stop and then release. Let the bike get up to speed again, this allows time for cooling and prevents too much heat buildup, repeat several times. You should be able to feel the brake power increasing with every stop, end the procedure when you achieve good braking performance.

Sintered pads take longer to bed in than organic pads, a general rule is that the more durable the pad compound is, the longer it will take to bed in. The brake will reach its full potential after a few rides.

HOPE brake pads wear limit

The limit when HOPE pads are considered worn or require replacement with new pads is when they have less than 0.5mm of brake compound (excluding the backing base).

If the pads have less than the above amount of compound, we recommend replacing them immediately with new ones to avoid damage to the braking system or injury to the rider!

Brake pads HOPE by Galfer characteristics