Brake pads HOPE E4, M4, RX4 Shimano, RX4+, road, blue

• HOPE Road pads suitable for brake caliper models: HOPE E4, RX4+, RX4-Shimano, Mono M4
• HOPE Road brake pads are designed for use on road bikes
• this pad compound has been developed to cope with increased speeds and braking at high speeds
• at the same time, emphasis is placed on maximum control of braking performance in both dry and wet conditions.
• when used with original HOPE Floating Road discs, a reduction in vibration during braking and under high loads has also been achieved.

We recommend using these brake pads on road bikes or gravel bikes. Although they are also compatible with E4 or Mono M4 MTB calipers, we do not recommend using them in MTB conditions!

Brake pads compactible with brakes

• HOPE Tech 3 E4
• HOPE Tech 4 E4
• HOPE Race Evo E4
• HOPE Stealth E4
• HOPE Mono M4 (from 2004)
• HOPE Tech M4
• HOPE Tech Evo M4
• HOPE Race Evo M4
• HOPE RX4-SH (Shimano)
• HOPE RX4+

Package content

• 2x brake pad HOPE Road (for 1 brake)
• 1x expansion spring between the brake pads
• 1x brake pads retaining pin
• 1x locking cotter pin of the locking screw

Brake pads bedding process

To achieve maximum braking performance all newly fitted pads will need bedding in, this is an important process and should not be skipped. If pads are not bedded in the pad surface will become glazed, severely affecting the frictional properties of the pads, resulting in poor braking performance.

To bed in the pads, ride at a moderate speed, rolling down a gentle slope is perfect. Gently apply the brake without attempting to fully stop and then release. Let the bike get up to speed again, this allows time for cooling and prevents too much heat buildup, repeat several times. You should be able to feel the brake power increasing with every stop, end the procedure when you achieve good braking performance.

Sintered pads take longer to bed in than organic pads, a general rule is that the more durable the pad compound is, the longer it will take to bed in. The brake will reach its full potential after a few rides.

HOPE brake pads wear limit

The limit when HOPE pads are considered worn or require replacement with new pads is when they have less than 0.5mm of brake compound (excluding the backing base).

If the pads have less than the above amount of compound, we recommend replacing them immediately with new ones to avoid damage to the braking system or injury to the rider!

Brake pads HOPE characteristics